OTD AUTOMATION PHÂN PHỐI CUNG CẤP SẢN PHẨM TỰ ĐỘNG HÓA

Đại lý
Tin tức
Liên hệ
Newsletter

Sign up for Newsletter
Signup for our newsletter to get notified about sales and new products. Add any text here or remove it.
Error: Contact form not found.

OTD AUTOMATION PHÂN PHỐI CUNG CẤP SẢN PHẨM TỰ ĐỘNG HÓA

Hotline: 090 153 2299

Bộ điều khiển IC695CRU320

Thông số kỹ thuật bộ lập trình GE IC695CRU320-EX

đại lý GE | nhà phân phối GE | GE việt nam

CPU Performance	For CRU320 performance data, refer to Appendix A of the PACSystems CPU Reference Manual, GFK-2222V or later.
Battery: Memory retention	For battery selection, installation and estimated life, refer to the PACSystems RX3i and RX7i Battery and Energy Pack Manual, GFK-2741
Program storage	Up to 64 MB of battery-backed RAM 64 MB of non-volatile flash user memory
Power requirements	+3.3 Vdc: 1.0 Amps nominal +5 Vdc: 1.2 Amps nominal
Operating Temperature	0 to 60°C (32°F to 140°F)
Floating point	Yes
Time of Day Clock accuracy	Maximum drift of 2 seconds per day
Elapsed Time Clock (internal timing) accuracy	0.01% maximum
Embedded communications	RS-232, RS-485
Serial Protocols supported	Modbus RTU Slave, SNP, Serial I/O
Backplane	Dual backplane bus support: RX3i PCI and high-speed serial bus
PCI compatibility	System designed to be electrically compliant with PCI 2.2 standard
Program blocks	Up to 512 program blocks. Maximum size for a block is 128KB.
Memory	%I and %Q: 32Kbits for discrete %AI and %AQ: configurable up to 32Kwords %W: configurable up to the maximum available user RAM Symbolic: configurable up to 64 Mbytes
Flash memory endurance rating	100,000 write/erase cycles minimum
Memory error checking and correction (ECC)	Single bit correcting and multiple bit checking.
Switchover Time	Maximum 1 logic scan, minimum 3.133 msec.
Typical Base Sweep Time (Reference Data Transfer List Impact)	3.66 msec: 1K Discrete I/O, 125 Analog I/O and 1K Registers 3.87 msec: 2K Discrete I/O, 250 Analog I/O and 2K Registers 4.30 msec: 4K Discrete I/O, 500 Analog I/O and 4K Registers 5.16 msec: 8K Discrete I/O, 1K Analog I/O and 8K Registers
Maximum amount of data in transfer list	Up to 2 Mbytes
Number of redundancy links supported	Up to two IC695RMX128/228 synchronization links are supported.

Mã hiệu	Thông số kỹ thuật
Bộ điều khiển IC695CRU320-EW	Add support for HART® Pass Through feature. Refer to PACSystems RX3i HART Pass Through User Manual, GFK-2929.
Bộ điều khiển IC695CRU320-EV	The CRU320 now supports 255 PROFINET I/O Devices in a PACSystems RX3i Hot Standby CPU Redundancy system. PROFINET operation uses the PROFINET I/O Controller module IC695PNC001. Redundant operation conforms to PROFINET V2.3 Type S-2 System Redundancy. PROFINET I/O operation in a HSB CPU Redundancy system is described in the following user manuals: • PACSystems Hot Standby CPU Redundancy User’s Manual, GFK-2308K • PACSystems RX3i PROFINETIO Controller User Manual, GFK-2571D
Bộ điều khiển IC695CRU320-EU	Adds support for IC695RMX228 128 MB Reflective Memory Module with Single Mode Transceiver. Adds ability to read reflective memory status bits for IC695CMX128, IC695RMX128, and IC695RMX228 (reflective memory modules). Resolves issue of Serial I/O Read Bytes COMMREQ (4402) always returning error code 100Dh in the event of an error, regardless of the error.
Bộ điều khiển IC695CRU320-ET	Adds support for the new IC695ECM850 (IEC 61850 Ethernet Communication Module), which operates as an IEC 61850 Client and provides connectivity to IEC 61850 Server devices. Resolves issue of CPU halting when the inner FOR_LOOP’s Start is greater than End input in a nested FOR LOOP.
Bộ điều khiển IC695CRU320-ES	Adds remote PROFINET IO to PACSystems RX3i Hot Standby Redundancy systems. Resolves issue with LREAL operands within complex relational expressions.
Bộ điều khiển IC695CRU320-ER	Resolves an issue where the CRU320 would go into halt mode when downloading to a CRU320 (Firmware 7.70 and later) that has GBCs in the configuration and the partner CRU320 is not configured.
Bộ điều khiển IC695CRU320-EP	Resolves the three issues listed in PACSystems RX3i CPU IC695CRU320 IPI, GFK-2514T.
Bộ điều khiển IC695CRU320-EN	Corrects an issue in versions 7.15 – 7.70 that required setting OEM lock in Enhanced Security in order to preserve the OEM lock through a power cycle. Adds support for RX3i CMX/RMX modules version -CG (hardware version Cx with firmware version 2.00 and later).
Bộ điều khiển IC695CRU320-EM	Adds support for the following new modules: IC694MDL758 and IC695CNM001.
Bộ điều khiển IC695CRU320-EL	Adds the ability to monitor a new interface between the CPU and the CMX/RMX Memory Xchange modules (CMX/RMX Memory Xchange module firmware 1.06 and later). In the rare occasion the CMX/RMX Memory Xchange module detects a failure in a read operation, the CMX/RMX Memory Xchange module will indicate the last read is invalid. The CPU will then retry the previous read operation.
Bộ điều khiển IC695CRU320-EK	Adds the ability to monitor the new queue alignment flag provided by CMX/RMX Memory Xchange modules with firmware version 1.05 or greater. If a queue alignment problem is detected, the CPU retries the read operation where the problem occurred.
Bộ điều khiển IC695CRU320-EJ	Adds native support for the IC694PSM001 module and resolves several issues. Also introduces new features to augment security in the CPU firmware and Proficy Machine Edition software. For details, see PACSystems RX3i CPU IC695CRU320 IPI, GFK-2514N
Bộ điều khiển IC695CRU320-EH	Corrects the issue described in PACSystems RX3i CPU IC695CRU320 IPI, GFK-2514M.
Bộ điều khiển IC695CRU320-EH	Corrects issues with Logic Driven Write to Flash (Service Request 57) and Run mode store in HSB redundancy systems with synchronized CPUs.
Bộ điều khiển IC695CRU320-EG	Corrects an issue with the RS-485 (COM2) serial port.
Bộ điều khiển IC695CRU320-DF	Corrects the behavior of the Logic Driven Read/Write to Flash service requests, SVC REQ 56 and SVC REQ 57.
Bộ điều khiển IC695CRU320-DE	Implements a hardware design update that improves the noise immunity of the CPU module during power up from flash operations.
Bộ điều khiển IC695CRU320-CE	For features introduced and problems resolved, see PACSystems RX3i CPU IC695CRU320 IPI, GFK-2514G.
Bộ điều khiển IC695CRU320-CD	Provides capability for low battery detection. The new hardware is EU-ROHS compliant. For details, see PACSystems RX3i CPU IC695CRU320 IPI, GFK-2514F.
Bộ điều khiển IC695CRU320-BC	Provides for OEM protection in flash-based systems that do not use a battery. For additional problems resolved, see PACSystems RX3i CPU IC695CRU320 IPI, GFK-2514E.
Bộ điều khiển IC695CRU320-BB	See PACSystems RX3i CPU IC695CRU320 IPI, GFK-2514D for new features and problems resolved.
Bộ điều khiển IC695CRU320-BA	Hardware-only upgrade to enhance manufacturability. Does not affect product features or functional compatibility.
Bộ điều khiển IC695CRU320-AA	Initial release.

Brand

GE

Đánh giá

Chưa có đánh giá nào.

Hãy là người đầu tiên nhận xét “Bộ điều khiển IC695CRU320” Hủy

CÔNG TY GIẢI PHÁP VÀ THIẾT BỊ TỰ ĐỘNG HÓA OTD